คำตอบที่ 118
วิธีเอา Lodge of the ring ออก....หลายวิธีดีจัง อิอิ
เค้าใช้ gas เป่า..........the shop people are just lazy bastids then.....i have never had 1 crack on me on the 11x billion sets we have swapped out for folks....it seems when TJ guys get spares they usually get non ABS ones from a cherokee ,etc, all i have ever had to do was heat the ring with a propane torch, then tap it off a little with a hammer an it will fall right off, heat it a little more and tap it onto the new shaft
__________________
93 ZJ, 4.0, np242, 4 in F>R , 33's, Arb Bumper, Warn XD 9000, Home depot Rack, lightfoce 170's and some blingy shny 5 star rims,8.8 lsd, d30 /ox locker, JCR Rock Rails
74 CJ5- total restoration from ground up, 3 spd, 304 V8, 32's
เค้า ดึงด้วย ตัวดึง/// press เข้า
just use any bearing puller. No torch needed
Old tone ring should go on new axle shafts without any modification.
Just remove them from old shafts, wire brush them good (they will look like new) and press them on.
You can use 2" PVC pipe to get the tone rings started (about half way)
than finish seating them with an aluminum punch
http://www.jeepforum.com/forum/f13/abs-tone-ring-removal-342299/
link นี้ ภาพไม่มา internet มี ปัญหา อิอิ
ผมเคยใช้ เครือง อัด ไฮโดรลิค อัด เข้า และ ออก เด้อ...